Any machine should be used in accordance with the provisions of the operation, bus processing machine is also reasonable operation is conducive to the extension of the service life of the machine. Before operation: 1. Oil must be filled to the oil tank before starting up for the first time to avoid damage to the oil pump. 2, must read this operation manual carefully, familiar with the machine structure, performance and operation method. 3. Do not wear scarves or coats. 4, with the correct way to work, in order to stop as soon as possible in the event of failure and get rid of danger. 5. If the ambient temperature is below 0℃, the machine should be turned on for several minutes before working. Operation: 1, installation, debugging (mold, adjust blade clearance) or disassembly mold, must be familiar with the machine personnel in accordance with the prescribed procedures. 2. When the machine is working normally, do not put your hand or part of your body between the upper and lower molds (blades) to avoid accidents. 3, all sundries and tools should not be put on the work table, in order to avoid rolling into the mold or knife edge and causing accidents. 4, because this machine can be operated by many people, so there must be a special person responsible for directing the production. 5. Be sure to choose the clearance and radius of bending fillet of shear blade and die according to the thickness of copper row (or aluminum row). 6, in the replacement of the mold must be shut down, in order to avoid danger. 7. In operation, be careful when holding the workpiece and waiting for the slider to go down. 8. Check the sharpness of the blade and die edge regularly. If it is found that the edge is blunt, it should be repaired or replaced in time. 9. Keep the oil clean and smooth, add lubricating oil to the moving parts of each unit in each shift. 10, the electrical and hydraulic components must ensure that the action is flexible and the position is correct, abnormal phenomenon must be immediately stopped for inspection. After operation: after operation, be sure to shut down safely in the following order: (1) Turn off the working buttons of each unit. (2) Turn off the power switch on the operating panel. (3) Turn off the main circuit air switch. (4) Turn off the power switch in the workshop.