In order to make the equipment work well, extend the service life of the equipment and cause unnecessary loss, please read the operation instructions carefully. The power supply of the equipment adopts 380V three-phase four-wire system (one of which is ground wire), and the power of each motor is 4KW. Please select the corresponding power cord. 1. It is necessary to fill the oil tank before starting the machine for the first time to avoid damage to the oil pump. 2. It is necessary to read the operation manual carefully and be familiar with the layout, performance and operation method of the machine. 3. Do not wear scarves or coats. 4, with the right way to operate, in order to quickly park and get rid of the risk in the event of failure. 5. If the ambient temperature is lower than 0℃, it should be turned on for several minutes before operation. 1, installation, debugging (mold, adjust blade gap) or disassembly mold, it is necessary to be familiar with the machine personnel in accordance with the rules of the rules. 2. When the machine is in normal operation, do not put your hand or part of your body between the upper and lower molds (blades) to avoid trouble. 3, all sundries and things do not put on the working table, to avoid rolling into the mold or knife edge and cause trouble. 4, because this machine can be operated by many people, so it is necessary to have a special person as the command of production. 5, must be according to the thickness of the copper row (or aluminum row) to choose a good shear blade and die gap and bending fillet radius. 6, when replacing the mold, it must be stopped to avoid the risk of attack. 7. In operation, it is necessary to be careful when holding the workpiece and waiting for the slider to go down. 8. Check the sharpness of the edge of the blade and die regularly. If the edge is found to be blunt, it should be repaired or replaced in time. 9. Keep the oil clean and smooth, add lubricating oil to the moving parts of each unit in each shift. 10. It is necessary for electrical and hydraulic components to ensure sensitive action and correct orientation. It is necessary to park the car immediately when abnormal phenomena are found. After the operation, it must be safely shut down in the following order: (1) Turn off the operation buttons of each unit. (2) Turn off the power switch on the operating panel. (3) Turn off the main circuit air switch. (4) Turn off the power switch in the workshop.