Analysis of copper bar installation knowledge of copper bar processing machine
- Author:
- Origin:
- Time of issue:2013-11-07 00:00
Analysis of copper bar installation knowledge of copper bar processing machine
- Origin:
- Time of issue:2013-11-07 00:00
1. Installation of the control bar: the control bar has two types: copper pipe and flat bar. According to the mark on the copper bar, the cabinet number and the corresponding busbar clamp shall wear the copper bar, and tighten the busbar clamp screws and copper bar screws. 2. Main busbar installation: unpack the copper bar, loosen the busbar clamp screws in the cabinet, wear the copper bar according to the mark on the copper bar, three-phase sequence and the position of the busbar clamp, tighten the busbar clamp screws, tighten the busbar screw, connect the main busbar to connect the cable. 3, ground row, zero row installation: the ground row according to the mark on the copper bar is generally installed in the lower front of the cabinet, directly connected to the cabinet; The zero bar is generally installed at the bottom and rear of the cabinet body according to the mark on the copper bar, and installed on the insulation grease. The above is a small series of copper bar installation of copper bar processing machine, thank you for viewing the products released by our company! Would you like to know more about our products? If you need other materials, welcome to inquire copper processing machine, the company will provide reasonable prices and quality assurance.
CONTACT INFORMATION
Yunnan multifunctional fillet machine - Yunnan bus bar processing machine - Kunming copper bar processing machine
Service hotline: 0871-68310369 18587197072 19969242964
e-mail address: crazer70@qq.com
Company address: No. 1028, Haiyuan Middle Road, national high tech Industrial Development Zone, Kunming
ONLINE MESSAGE
Copyright: Kunming KUNKAI special numerical control equipment Co., Ltd. Yunnan ICP preparation No. 11004860-1 website construction: China Enterprise Power Kunming SEO