News Center

Analysis of alternative cleaning method of copper bar processing machine

  • Author:
  • Origin:
  • Time of issue:2013-11-05 00:00

Analysis of alternative cleaning method of copper bar processing machine

  • Origin:
  • Time of issue:2013-11-05 00:00

Copper processing machine cleaning has been a lot of people's problem, now xiaobian for you to introduce a more alternative but effective method for your reference. Copper processing machine because of the use of a long time, soft dry oil or antirust paste hardened bearings, immersed in 100-200 degrees of hot oil, with pliers clamp bearing, brush clean bearing oil. Soft dry oil or antirust paste is heated to 100-200 degrees to melt, very simple from the bearing gap washed out. Sometimes as long as the bearing in the oil repeatedly shake. Oil can also run through the cracks. Easy steps to remove stains. Especially in the cleaning of the old copper bar processing machine motor or imported motor centrional spherical bearings, you should be able to turn out of the hot oil in the part, are put into them, this application of two different substances solution point method, is simple and efficient. Special attention: when cleaning with hot oil, the oil temperature should not exceed 200 degrees. If use open fire direct heating, should pay attention to avoid burning oil, bearing should be suspended in the oil pan, bottom will cause overheating and decrease hardness.


Yunnan multifunctional fillet machine - Yunnan bus bar processing machine - Kunming copper bar processing machine


Service hotline: 0871-68310369  18587197072  19969242964


e-mail address:


Company address: No. 1028, Haiyuan Middle Road, national high tech Industrial Development Zone, Kunming


Username used for comment:

Copyright: Kunming KUNKAI special numerical control equipment Co., Ltd. Yunnan ICP preparation No. 11004860-1 website construction: China Enterprise Power Kunming SEO