I believe that we are already very familiar with the copper processing machine, but do you understand the production process requirements of copper processing machine? In order to make you better operation of copper bar processing machine, the following small series for you to introduce the production process requirements of copper bar processing machine, I hope to bring you help. 1, copper bar tapping: copper bar processing machine copper bar tapping, to determine whether the aperture of the bottom hole meets the requirements, and then choose the corresponding tap tapping. 2, copper bar marking: marking should be reasonable according to the position of the hole, reduce unnecessary lines; Pay attention to the strength of the hand, so that there is no scratch on the surface of the copper bar; See clearly on the drawing marked size, aperture size. 3, copper bar blanking: according to the specifications of copper bar processing machine blanking; Before blanking, use calipers to measure the material width and thickness of the copper bar, and then blanking after determining that it meets the requirements; Place the copper bars neatly to avoid scratches. 4, bending copper bar: copper bar should be selected according to different thickness of the corresponding mold; After adjusting the mold, be sure to use waste to try the knife to avoid defective products; The bending operator should do self-test after folding. Check with the inspector after confirmation. 5, pressure riveting: the requirements of the copper bar processing machine pressure riveting insert specifications and pressure on the surface of the copper bar; In the pressure riveting machine to choose the right pressure, to avoid the pressure will be too large copper bar pressure injury; The surface of the riveting machine or copper bar should be protected to avoid scratching and crushing the copper bar. 6, copper bar drilling: drilling should see the size of the copper bar file aperture, the corresponding size of the drill to drill; After drilling copper bars should be neatly placed; When drilling, operators should not wear gloves and keep a certain distance between their hands and the drill to ensure their own safety. 7. Copper bar inspection: the first product produced by each process shall be self-checked to be qualified and then submitted to quality control for the first inspection. Mass production can be carried out only after the first inspection is qualified by quality control. After bending, the inspector should check the bending size, Angle and direction of the copper bar, and make sure there is no problem before outsourcing. 8, copper bar processing machine production self-inspection items: blanking size, marking position, drilling aperture and hole position size, tapping specifications, round hole & waist round hole specifications. Meet the specification requirements, tapping bottom hole in line with the fourth requirement of this specification; Pressure riveting insert specifications and pressure riveting direction, bending size and direction. The position of the outer corner of the bending can not have orange peel crack; Copper bars are long conductors with rectangular or chamfered rectangular sections. They transport current and connect electrical equipment in the circuit. Generally, copper bars are used in U, V and W bus bars and PE bus bars in the power distribution cabinet. The above is the production process requirements of copper bar processing machine, I hope these can help you, because the copper bar processing machine is very important for our life, so the operator to understand the production process requirements of copper bar processing machine is very important. In addition, if you need copper bar processing machine, welcome to order, quality products and professional service to ensure your satisfaction!