News Center

Daily maintenance of copper bar bending machine

  • Author:
  • Origin:
  • Time of issue:2014-10-29 00:00

Daily maintenance of copper bar bending machine

  • Origin:
  • Time of issue:2014-10-29 00:00

In daily work, how to maintain the copper bending machine, in order to prolong its life? In this brief introduction about the maintenance and maintenance of copper bar bending machine.

First of all, when the copper bending machine does the bending work of raw materials, it is necessary to align the center position of the bent raw materials with 0 degrees of the copper bending machine itself. If it is not aligned, it begins to bend, and the accuracy of bending will be seriously affected. Secondly, when the copper bending machine does the bending work of some special materials, it is necessary to know how much the maximum bending Angle of the material is, because the maximum Angle of many materials is 90, if more than this Angle will damage the material, so that the material becomes very easy to break. Finally, when the copper bending machine does a series of bending operations, check whether the copper bending machine head is distorted, if the bending should be adjusted or replaced in time.

In addition to work, in life also pay attention to the following points.

1. Hydraulic oil circuit: check the oil level of the tank every week, and check the oil level after the maintenance of the hydraulic system. If the oil level is lower than the oil window, add hydraulic oil; Each oil change, should clean the oil tank; The system oil temperature should be between 35℃ and 60℃.

2. Filter: Every time the oil is changed, the filter should be replaced or thoroughly cleaned; The machine should be replaced if there is a related alarm or oil is not clean and other filter abnormalities. The air filter on the fuel tank should be checked and cleaned every three months, preferably a year.

3. Hydraulic parts: clean the hydraulic parts every month to prevent dirt from entering the system, and do not use detergent; After a month of use of the new machine, check whether the bending of each oil pipe is deformed. If there is any abnormality, it should be replaced. After two months of use, the connection of all accessories should be tightened.

For more content, please pay attention to Kunming Kunkai Company!



Yunnan multifunctional fillet machine - Yunnan bus bar processing machine - Kunming copper bar processing machine


Service hotline: 0871-68310369  18587197072  19969242964


e-mail address:


Company address: No. 1028, Haiyuan Middle Road, national high tech Industrial Development Zone, Kunming


Username used for comment:

Copyright: Kunming KUNKAI special numerical control equipment Co., Ltd. Yunnan ICP preparation No. 11004860-1 website construction: China Enterprise Power Kunming SEO